安裝。
K系列本安型安全柵 K 系, convert input signals to digital output signals and transfer switching signals to a control device such as DCS or PLC
The switch isolator consists of three primary components: the power supply, the transistor switch amplifier and the output stage. Galvanic isolation separates the input, output and power supply circuits.
Software user interface for Advanced Diagnostic Modules, Access to mobile ADM via USB-port,
Embedded expert system gives pointed advice in clear text, Includes Commissioning
全系列的產品用于保護危險區中的電信號。本質安全模塊主要由限能齊納柵和電氣隔離組成。倍加福公司產品滿足各種應用,適合多種with DIN EN60947 (NAMUR). This means the residual voltage in normal operation is approximately 8 VDC and the short circuit current is approximately 8 mA. The switch points are typically between 1.2-2.1 mA
Many Pepperl+Fuchs isolators offer optional lead breakage and short circuit monitoring (activated by slide switches) for the hazardous area circuit. These isolators feature three outputs that can be reversed using the mode of operation switch: relay, active transistor and passive transistor outputs
K系列隔離式安全柵能夠為用戶提供全方位的解決方案,K系列安全柵保證現場設備和控制室之間可靠&經濟的信號傳送。無論用戶單一的選擇信號隔離模塊或者進行大規模的系統
每個通道輸出1路繼電器觸點
列(導軌式)
得到廣泛應用的K系列本安型隔離柵采用DIN導軌安裝,靈活方便。K系列本安型安全柵可以插接到與DIN軌道組裝在一起的電源導軌上,簡便易行。此安裝方式,相對于DIN導軌安裝而言,可極大節省了模塊供電端的電源線及接線。
H系列本安型安全柵
隔離式安全柵把數字信號傳送到危險區。符合EN60947-5-6標準(NAMUR)的傳感器或 機械接點可當作變送器使用。控制電路中帶有斷路監測功能。
? 1-/2-通道
? 控制回路 EEx ia IIC
? 230V/115V 交流供給電壓
? 正/反操作模式
? 斷路監測35mm DIN導軌內,只需簡單的固定安裝到位即可。供電導軌在給模塊供電的同時,還可以采集各個模塊的故障信息。使用導軌供電的方式極大的減少了布supply power to the proximity sensor in a hazardous area, receive a proportional current